 |

The Rock Racing Batteries, Inc.
RC12V DLS Power Charger User Instructions
Basic Instructions to begin using the Rock’s Power Charger.
MODES
The RC12V Battery Charger has 3 basic programmable modes for charging batteries. In addition this charger is capable of doing so at two separate voltage levels for 12 and 16 volt batteries. This charger can be set to charge batteries for a period of time in each mode or do so automatically. Turbo Mode for charging AGM and High Performance batteriesRegular Mode for charging Flooded Lead Acid BatteriesSoak Mode for topping off batteries, trickle charging, and to protect from overcharging.
VOLTAGE 16v Enabled
The RC12V battery charger is designed to operate in 12v mode by default. However, this model is designed to charge 16 volt batteries as well. 16V Mode changes the voltage from 12 volt applications to 16 volt applications. 16 Volt Mode charging has the same Turbo, Regular, and Soak modes but does so at different voltage levels to compensate for these batteries.
Button Instructions
MANUAL TURBO MODE
Hold both black buttons down to Access Turbo Mode.
After the buttons are released you will be able to move the timer for minutes up or down.
MANUAL SOAK MODE
Hold both black buttons down again to Access Soak Mode.
After the buttons are released you will be able to move the timer for minutes up or down.
Exit Modes
Hold both buttons down again to exit all Modes.
Charging 16 Volt Batteries
Hold both black buttons down, the LCD will display
Turbo minutes, continue to hold buttons down and
the display will read 16 Volt enabled. Use the different
mode instructions to set minutes.
Example:
*Do not plug charger in before connecting cables to post.
-
Connect charger cables to battery terminals.
DO NOT PLUG IN CHARGER.
Red+positive Black–negative -
ONCE CHARGER AND BATTERY ARE PROPERLY CONNECTED WITH THE CHARGER
UNPLUGGED, The LCD Display will list the following:
EXAMPLE
| Mode | Mins | Volts |
| Turbo | 60 | 11.60 |
The Battery Charger will display a Green flashing light if the battery needs to be charged. -
To begin charging, plug in the charger. Charger will start the "Turbo Mode" for 60 minutes. The charging voltage will register between 14.74 to 14.76.
-
After the "Turbo Mode" cycle is complete, the charger switches into the "Soak Mode". This will protect the battery from overcharging.
-
The RC12V Battery Charger will continue to operate in "Soak Mode" until either the circuit with the battery or the wall socket are terminated.
-
RC12V will not over charge the battery.
|
1 16 Volt Battery & 16 / 12 Volt Battery Race Cranking Amps:
5 seconds continuous @ 75°F to 7.2 volts = 1050 Amperes
15 seconds continuous @ 75°F to 7.2 volts = 950 Amperes
30 seconds continuous @ 75°F to 7.2 volts = 750 Amperes
Click for 16 Volt Battery Info |
|